DSP4YOU PWR-DSP1 Bedienungsanleitung PDF herunterladen (Seite 13)

PWR-DSP1 User Manual

Page 13 of 23

Copyrights DSP4YOU ltd

Step5: With the software up and running, you’re now ready to configure your PWR-DSP1.

4 System Configuration

4.1 User interface overview

The AVBStreamer Toolbox provides a simple user interface for configuration of the AVB and DSP setting of PWR-DSP1

units. The architecture of the software can be seen below:

 A Device tree on the left side lists all discovered AVB devices and Virtual devices

 A center section tabbed based structure allows access to the various sections of the user interface

Tabbed Structure organized in 3 main tabs:

 Device tree: Lists devices currently connected and discovered on the network.

 Device info: Provides overall view of the current settings of the selected PWR-DSP1 device including the

model number, firmware version, IP settings.

 Audio settings: Digital Signal Processing section of the interface. Provides control to the basic gain control

and advanced DSP algorithms running on the on board Digital Signal Processor.

 System settings: Allows loading, saving and restore to default of a configuration.

4.2 PWR-DSP1 configuration

4.2.1 Device Tree

Thanks to the Zero Config and self discovery embedded technology, PWR-DSP1 units are automatically discovered

once connected to the network. The Device tree on the left allows instant access to any units currently connected to

the Ethernet/Wifi network. Note that while units can be controlled / monitored over a standard Wifi network, AVB

(audio streaming) requires a 100Mbps Ethernet network.

The AVBStreamer Toolbox allows configuration of units in two modes

- ONLINE mode to be used for units currently connected to the network

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Keine Kommentare

DSP4YOU PWR-DSP1 Bedienungsanleitung Seite 13